Frequency list 400 channels mode
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | |
|---|---|---|---|---|---|---|---|---|
| 0 | 0 | 1 | 0 | 0 | 0 | 0 | 0 | HAM-Radio - 28.000MHz to 29.700MHz |
| 0 | 0 | 1 | 0 | 0 | 0 | 1 | 0 | HAM-Radio - 25.000MHz to 29.700MHz |
| 0 | 0 | 0 | 0 | 1 | 0 | 1 | 1 | 400 Ch. FM and AM |
| 0 | 0 | 0 | 0 | 1 | 0 | 0 | 1 | 400 Ch. FM |
| 0 | 0 | 0 | 0 | 1 | 0 | 0 | 0 | 200 Ch. FM and AM |
| 0 | 0 | 0 | 0 | 0 | 1 | 1 | 1 | 200 Ch. FM |
| 0 | 0 | 0 | 0 | 0 | 1 | 1 | 0 | 12 Ch. AM 1 Watt and 80 Ch. FM 4 Watt |
| 0 | 0 | 0 | 0 | 0 | 0 | 1 | 0 | 40 Ch. AM and FM |
| 0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 40 Ch. FM (CEPT) |
 |
T101 RF Input
|
| Pin | Name | Description |
|---|---|---|
| 1 | TD | To CTCSS board |
| 2 | FB+ | Positive supply voltage to VCO PCB |
| 3 | RX B+ | Positive supply voltage to Receiver and IF amplifier |
| 4 | PD | VCO voltage from PLL (CPU) |
| 5 | TX | TX signal to Transmitter and VCO |
| 6 | FIN | VCO frequency to PLL (CPU) |
| 7 | A/F | AM/FM Modulation |
| 8 | SW B+ | Positive supply voltage fron ON/OFF switch |
| 9 | H/L | High/Low RF Power Control |
| 10 | B BAND | B Band (Not in use) |
| 11 | BATT | Positive supply voltage from battery |
| 12 | BATT | Positive supply voltage from battery |
| 13 | AF | Audio signal (To AF amplifier) |
| 14 | U.L. | UnLoock from CPU |
| 15 | MIC | Microphone signal |
| 16 | S RF | S-Meter to CPU |
| 17 | SQ | Squelch signal to CPU |
| 18 | A BAND | A Band (Not in use) |
| 19 | GND | Negative supply voltage |
| 20 | TC | To CTCSS board |
TK10930V FM/AM IF and Detector